Darex XPS-16 Operating Instructions Manuel d'utilisateur télécharger pdf (Page 55)

Do not use sharpener until vacuum

system is connected to machine. The

airflow from the vacuum system

keeps the grinding wheel & motor cool

while running. Damage to the motor may

occur if vacuum is not running while sharp-

ening on the XPS-16.

XPS-16 VACUUM SYSTEM

The XPS-16 sharpener comes equipped with an

environmentally safe dust collection system. Hook

up the vacuum to your sharpener before sharpen-

ing drills.

HOW TO HOOK UP VACUUM

SYSTEM

1. Connect plug from vacuum to the receptacle

on the electrical panel located at the back of

the XPS-16 sharpener.

2. Connect Vacuum hose to the vacuum adapter

tube on the sharpener and to the intake tube

on the vacuum.

VACUUM SYSTEM DISASSEMBLY &

MAINTENANCE

1. Using a ¼ hex key wrench, remove bolt and

washer.

2. Remove top ½ cover of vacuum canister.

3. Remove and dispose of filter cartridge.

4. Unthread plastic nut retaining bottom ½ of

vacuum canister.

5. Remove bottom ½ of vacuum canister.

6. Clean out residual grinding dust from bottom

of canister.

To reassemble, reverse steps.

NOTE: When reassembling, make sure the

rim of the top ½ of vacuum canister is

seated into gasket channel on bottom ½ of

vacuum canister.

VACUUM SYSTEM AND

INSTALLATION INSTRUCTIONS

Vacuum System Information

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 127 128

Pas de commentaire

Darex XPS-16 Operating Instructions Manuel d'utilisateur Page 55